板间距的英文

• distance between plates

• 板    board; plank; plate
• 间距    interval; separation; spacin ...
• 挡板间距    baffle spacing
• 垫板间距    liner space
• 极板间距    plate clearance
• 肋板间距    floor space
• 热板间距    daylight between platens
• 三合板间距    ditriglyph
• 塔板间距    tray spacing
• 压板间距    daylight opening; daylight press opening
• 折流板间距    pitch of baffle
• 颚板间距    jaw opening; jaw setting
• 压机压板间距    daylight opening
• 压机压板间距数    number of daylights
• （空心锻件）压扁试验的板间距离    distance between plates for flattening] tests
• 间距    interval; separation; spacing; espacement; space; spacing; space length; range; unpack; step 一英里的间距 the space of a mile; 在设计房屋时, 两座房子之间要留出10码至20码的间距。 in designing the houses, space out them from 10 to 20 yards apart.; 间距调节 variable-spacing adjustment (播种的) ; 间距调节杆 spacing lever (中耕机锄铲的)
• 甲板间    between (or tween) decks; between decks; tweendeck
• 样板间    lishow/ model home; show/ model home
• 甲板间甲板间舱    tweendeck
• 凹板间隙    concave clearance; concave opening
• 板间成形    sheet-metal forming
• 板间的, 层间的    interlaminar
• 板间地震    interplate earthquake
• 板间盖条    splat
• 板间互作用    interaction with interelectrode

• Side bar space is accurately adjusted by numeric control panel
  侧板间距调整，用电控数字显示，尺寸精确。
• Experimental study of optimum wire spacings at different plate spacings of ep
  电除尘器不同板间距下最佳线间距的试验研究
• The lab table for the measurement of flow between two parallel planes is designed . the measurement of the laminar flow between two parallel planes that the distance between the two parallel planes is 2 . 25mm and 1mm is performed
  建立适于两平行平板间流动的测量平台，并使用mpiv对板间距h = 2 . 25mm和h = 1mm的两平行平板间层流流动进行测量，得到其充分发展段的速度分布。
• The results show that for all of parameters considered in this study , the friction factor of fin surface without vgs is smaller than that for fin surface with vgs ; the increase of friction factor under low reynolds number is large , but with reynolds number increasing , the increase of friction factor is quite small
  实验结果表明：在不同管间距、板间距时，板芯装涡产生器阻力系数均比光板板芯的阻力系数大，并且在低雷诺数时的增幅比较大，随着雷诺数的提高，阻力系数逐渐降低并趋于平缓，且阻力系数增幅大大减少。
• This thesis also studied the influence of the spacing , which is between the central action point on the shackle and the exterior plate of the chassis frame side rail , because the spacing influenced the local stress distribution and the stress concentration of the bus body frame and the chassis frame , and the related variational tendency was summarized
  本文还研究了吊耳销作用力中心点与纵梁腹板间距对车架和客车骨架的应力分布与集中的影响，总结了相关的变化趋势。
• It is validated that the numerical methods can absolutely predict the flow in the microchannels . the flow field around the roughness and the pressure drop of midline along flow direction are analyzed . it ' s found that the range of the pressure drop change relate to the magnitude of relative roughness , the distance between two parallel planes , the re number and ratio of the size of roughness and the distance between two roughness
  通过对粗糙元周围流场和充分发展段中心线压力曲线的分析，发现有粗糙元存在的两平行平板间微通道，其充分发展段压降大于光滑平板充分发展段压降；当相对粗糙度和re不变时，随着板间距的减小，粗糙度对主流的影响不断增大；当板间距和相对粗糙度不变时，在层流状态下，粗糙度对流动的影响不随re的变化而变化；当板间距和re保持不变时，相对粗糙度越大，其对流动的影响就越大。
• For hoods with shutters in four sides , the results show : 1 ) the hoods positively placed boards are called hoods used for venting airflow ; hoods negatively placed boards are called hoods used for leading airflow ; 2 ) among the hoods used for venting airflow , the most effective hoods should have positive declining angle value of 30 , the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ) , the value of b range from 70 mm to 120 mm and the value of b / h range from 0 . 5 to 0 . 6 ; 3 ) the most effective hoods should have negative declining angle value of 60 , the ratio 4 of areas between the four windward faces and the gular section ( fy / fj = 4 ) , the value of b range from 100 mm to 170 mm ( the optimum value is 120 mm ) and the value of b / h range from 1 . 4 to 2 . 2 ( the optimum value is 2 . 0 )
  对于四面设百叶型风帽，计算表明: l )正装倾斜挡板的百叶型风帽可认为是排风型风帽，倒装挡板倾斜的百叶型风帽可认为是进风型风帽; 2 )排风型风帽中，挡板正装30 ” 、风帽四个迎风面的有效面积fy和风管净断面积fj的比值( fy肠)为4 、挡板宽度b在70inln到120inln之间、板间距比值陇在0 . 5到0 . 6的百叶型风帽排风效果最好; 3 )进风型风帽中，挡板倒装装60 “ 、风帽四个迎风面的有效面积和风管净断面积的比值( fy例)为4 、挡板宽度b在100咖到170mm之间( 120mm为最佳) 、板间距比值陇在1 . 4到2 . 0的进风型风帽( b爪= 2 . 0为最佳)的百叶型风帽进效果最好。
• Abstract : in the light of the problem of multiple variables restrain in the design of pipe heat exchanger , it is proposed taking three variables , the pipe length , ratio between the table flap space and the shell outer diameter , and ratio between the pipe space and the pipe outer diameter , as optimization criterion
  文摘:针对管式换热器设计过程中几何关系的多自变量约束难题，提出了以管长、折流板间距与壳外径之比、管间距与管外径之比三个设计变量作为优化判据。