- condemnation factor
- condemnationfactor
- condernmation facte
- obsolescence factor
- scrappage
下载手机词典可随时随地查词查翻译
关注微信公众号：chachacidian，回复:报废率，即可在微信中查询翻译
报废率的英文
例句与用法
- 更多例句： 下一页
- Assists in managing workers and production quality to minimized rejections
协助监督工人工作及生产质量，最大限度地降低报废率 - Lead team to continue improvement current process , improve product quality , reduce scrap rate
带领团队不断提高现有的工艺流程，提高产品质量，降低报废率。 - Monitor and control mass production products status and take actions to reduce the scrap rate and improve the process capability
控制/监控量产的品质状况，采取行动降低报废率，改善制程能力。 - Installations for application and drying of paints and varnishes . application and combined booths . application by spraying . methods of measurement of rejects to atmosphere
涂料和清漆的应用及干燥设施.应用和组合间.受大气环境影响报废率的测量方法 - At the initial stage of planar technique , b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region , and the good shield effect of sio2 film to b . but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient , the linear slowly - changed distribution of acceptor b in pn junction can not be formed , which could not cater to the requirement of high - reversal - voltage devics . thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed , while the former can lead to relatively large the base - region deviation and abruptly varied region in si , which caused severe decentralization of current amplification parameter , bad thermal stability and high tr ; the latter needed the relatively difficult pack technique , with poor repeatability , high rejection ratio , and poor diffusion quality and productio n efficiency
在平面工艺初期，由于b在硅中的固溶度、扩散系数与n型发射区的磷相匹配， sio _ 2对其又有良好的掩蔽作用，早被选为npn硅平面器件的理想基区扩散源，但b在硅中的固溶度大( 1000时达到5 10 ~ ( 20 ) ，扩散系数小， b在硅中的杂质分布不易形成pn结中杂质的线性缓变分布，导致器件不能满足高反压的要求，随之又出现了硼铝涂层扩散工艺和闭管扩镓工艺，前者会引起较大的基区偏差，杂质在硅内存在突变区域，导致放大系数分散严重，下降时间t _ f值较高，热稳定性差；后者需要难度较大的真空封管技术，工艺重复性差，报废率高，在扩散质量、生产效率诸方面均不能令人满意。