实际工况的英文

• actual conditions

• 实际:    reality; practice
• 工况:    operating mode; working cond ...
• 跨实际工程:    a trans-century project
• 实际工期:    actual co truction time; actual construction time
• 实际工时:    actual hours; actual working hours

例句与用法

1. Coupled with the simulation of unsteady flow , the resonance analysis was studied . as an application , the dynamic stress of the blade was analysed with ansys based on the computation of unsteady flow . the result may be useful in the engineering practice
   还根据流场计算得出的叶片上非定常气动载荷，用ansys软件进行了叶片的动应力计算，由于较为接近实际工况，所得动应力值可能具有一定的工程参考价值。
2. 7 . according to the factual character , creating the tridimensional fmit element model under the factual work condition and the space effect , analysis the deforming phenomenon of pit . and analysis the factors " sensibility that influence pit ' s stability
   7 、根据工程的实际特点，建立基于实际工况的考虑空间效应三维有限元模型，对基坑的变形现象进行了分析，并对影响基坑安全稳定的各因素进行了敏感性分析。
3. In order to improve the friction between the outer diameter of dishing ring and cone , and prevent any contaminant , such as slurry and ect . from coming , the outside diameter may be curved upward . the length and open of the curved may be determined by the analogue to the actual condition
   为改善碟形圈外径与牙轮的摩擦工况，更好地防止泥浆等有害物质的侵入，可将其外径略向上弯曲，弯边的长度及开口数可由实际工况的模拟来确定。
4. We validated this system on the black - body oven , analyzed the errors which brought about by the optical system , ccd , surroundings and workers , expounded the improvement methods ; 5 . we had done many real measurements with this system . after analyzing the experiment results , we improved the original system and proposed a new system
   在自己研制的黑体炉上对系统进行了标定实验研究，对标定误差进行了分析，对消除光学系统、 ccd 、环境以及主观因素等对误差的影响提出了改进和处理方法，大量实验得出了较为稳定的标定测量值，为系统进行实际工况环境下的测量奠定了基础； 5
5. The definitions and the conditions of cavitation erosion and flash vaporization have been discussed in detail ; the paper also shows examples of different definitions in different books , which cause the complexity of calculating discharge factor and the damage to control valve ; suggests relevant measures to avoid the damage in real working condition
   摘要对气蚀和闪蒸的定义、产生的条件进行了详细论述，以规范不同版本书籍在概念上的模糊不清，以及由此造成的调节阀流量系数计算的复杂性和对调节阀的损害，以便采取相应措施，在实际工况条件下加以避免。